Share, , Google Plus, Pinterest,

Print

Posted in:

Ethernet Splitter For Computers


If you possess more than one computers at home or at work, more likely you will want to share the internet connection between all the computers so that all the occupants can access the internet at once. For this reason you can use an ethernet splitter to construct a set of connections where all the computers can be linked to utilize the internet connection. So the network is basically all the computers linked by a communications device that facilitates sharing information between all the users. tn pas cher

If it is not easy for you to buy an Ethernet splitter, then you can utilize this article to learn how you can make one by yourself. But it requires time, tolerance and a little knowledge of wiring. By setting up an Ethernet splitter, you will be able to connect two or more PC’s at the same time on one Ethernet device.
nike tn pas cher

In order to create your own Ethernet splitters you will require some devices and tools such as two RJ45 Crimpable Plug, four RJ-45 keystone jack, a small Ethernet Cable Scrap around 2 feet in size and instruments such as a RJ45 Crimp Tool Craft knife, 110 Punch Down Tool, Loctite A Super Glue. initially you will need to crimp the RJ45 Plug to the Ethernet cable. For this to be done you will need to follow a configuration codes taken from a hardware book or from the directions on the package.
nike pas cher

Now use the 110 Punch Down Tool to press down the other end to the RJ-45 keystone jacks and use the other side of the cable and slice it to 9 inches and press down the four pairs by using this wiring code, Jack 1: 1 White/Orange to pin 1keystone jack 2 Orange to pin 2 keystone jack 3 White/Green to pin 3 keystone jack 6 Green to pin 6 keystone jack 2: 4 Blue to pin 2 keystone jack 5 White/Blue to pin 1 keystone jack 7 White/Brown to pin.

Use the previous instructions to create one more splitter so you eventually have two splitters. Plug one splitter to the RJ45 wall plate and join the two PC’s to the splitter. Now connect the other splitter to the patch plate and put two patch cables from the splitter to two free Ethernet cables from the switch. If your splitter cables are right then the two leds from the knob on which the patch cord are joint should engage. After this setup is achieved, then you will be able to install two computer systems all at the same time connected with only one Ethernet cable. This method is similar to power over Ethernet but instead of inserting DC, it is insering another data. It is better if you can to draw one more Ethernet cable from the patch board to the wall plate. Once you use these guidelines then you should make a proper Ethernet splitter, if not you will need to restart the procedure all over again.

Please visit these links for more information on Ethernet Splitter and Ethernet Splitters
www.niketnpascherc.eu